The automatic die-cutting machine explains the operation of the die-cutting machine and the method of mold adjustment

Turn on the power supply and check the equipment! Test the machine for a few minutes before setting up the mold to ensure that the machine is working properly! The die must be straight when the die-cutting machine and the continuous machine are used for punching products, otherwise the punched product is likely to be out of material. Remove the template from the machine platform and place it on the workbench, stick the mold to the tape horizontal frame and stick it firmly on the upper template.

After installing the template, tighten the right or left screws and increase the pressure so that the gap between the upper and lower templates must be higher than the thickness of the mold plus the PC board. The lower template is fixed on the lower part of the mold with tape on the PC board. Stick the tape on the white paper and stick it on the other side of the PC board that is not taped. The PC board is underneath and the white paper is in the middle; after putting the carbon paper, slowly decrease the pressure, and use the host to tap in and slowly test the pressure until there is a whole knife on the white paper. The child of the mold.

　　 The stamp on the white paper is to facilitate the confirmation of the debugging position when printing the product. Place the paper under the PC board and use the positioning foam to make the positioning!

　　 Place the material for a test punch, remove the waste, and check the product. If the product is found to be continuous or has burrs, take out the paper placed under the PC board, and paste the transparent tape on the corresponding defect!

If you find product delamination or over-cutting, you should use a blade to gently scrape the corresponding defective part of the PC board! After the product trial adjustment is completed, the rack material is set to jump distance, etc.! The first mold product that has been rushed out and debugged should be confirmed by quality control, etc. After the quality control is confirmed, the product can be made! The product should be self-checked frequently until the production is completed!

　　 Label: Automatic Die Cutting Machine